Installing A Pe 260 Or 261 Motor Into The Pfaff 260 (-261) - Pfaff 260 Service Manual
Hide thumbs
Also See for 260:
- Service manual (90 pages) ,
- Instruction book (55 pages) ,
- Service manual (72 pages)
Table of Contents
Advertisement
Installing a PE 260 or 261 Motor
into
the Pfaff 260
(-261)
The motor
is
screwed to the underside of the bed plate of
the
machine.
To in-
stall the motor
in
the machine, place the
machine
in a universally adjustable
mounting
stand
and
turn
it
upside
down.
Then proceed as follows:
1.
Remove
cover
4 of the terminal box
located beside the sewing hook
(Fig.
114).
2
.
Turn the motor so that its driving
belt sprocket is at the
balance-
wheel-end of the machine, and
place it on the bottom of the
bed-
plate so
that
both
screwhol·
e s
in
the
motor bracket line up with tine corre-
sponding holes
in
the bedplate
(see
arrows in Fig.
115).
Fig.
114
3.
Turn screw A partway in,
insert
and tighten
screw
B, then
tighten
screw A
for good (Fig. 115).
4. Connect
the
short
end
of the motor cord to terminal 2,
the long
end to
terminal 1, as shown in
Fig.
114.
Secure the cable sheath in position by the
clip held in place by screw
3.
Replace and screw down the terminal box
cover.
5. loosen hexagon
screw
h (Fig.
118)
and return the machine to its normal
position in
the
mounting stand.
Fig. 115 Installing ond adjusting
the
Pfaff PE
260 (261)
motor
79
Advertisement
Table of Contents
