GE ZET1 Installation Instructions Manual page 5

Installation Instructions
A2} Cutout for Double Built-In Oven
cia 716
28 1/2" (19.7 cm) Cabinet Width 30" (76.2 cm)
. Max,
eg (72-4 cm) Min. be
12 eo T Recommended
Junction Box Vocation
Location
from Floor 12" (30.5 cm)
Allow 11/16" seme TY ook Cutout Depth 23 1/2" (59.7 cm) Min.
. f Saat
ar of oven — Lp : " :
over side edges of Between Cutout Width 28 1/2" (72.4 cm) Min.
cutout \ inside Walls 28 5/8" (72.7 cm) Max.
At Least . 7 :
\ 28 U2" wae 47" (119.4 em) Cutout Height 5113/16" (131.6 cm) Min.
Allow a minimum
of 21" (53.3 cm) for
clearance to adjacent
Cutout
Height
51 13/16"
corners, drawers, N Allow 1' (2.5 em)| || {131.6 cm) Min
walls, ete. when , minimum for 5115/16" (131.8
door is open . overlap of oven cm) Max.
\
. top and 1%" i
St 3.2m) overlap of i
oven bottom i
of cutout
wee] ot
oy"
Le
eo
(53.3 cm) a7"
51 15/16" (131.8 cm) Max.
Min. to Bottom of
Junction Box
la
NOTE: If the cabinet does
not have a front frame and the
sides are less than 3/4' (1.9 cm)
thick, shim both sides equally
to establish the cutout width.
Install a
Recommended cutout
location from floor
12" (30.5 cm)
solid bottom
or2" x4'
Cabinet
Width
If the cabinet does not have a solid bottom, two
braces or runners must be installed level with
the bottom of the cutout to support the weight
of the oven. For double ovens, the runners and
braces must support 375 lbs. (169 kg).
{5 cm x 10 cm) or
equivalent runne
level with bottom
of cutout
NOTE: If marks, blemishes or the cutout
opening are visible above the installed
oven, it may be necessary to add wood
shims under the runners and front trim
until the marks or opening
are covered.
Suitable Beta nnn pon ety
Bracing
to support z i sie
(54.9 cm)
Over Centerline
+—
of Cabinet
The solid bottom or runners must be level with
the bottom of the cutout, or the bottom trim
may not install correctly and then interfere
with the door opening.