GE ZET1 Installation Instructions Manual page 11

Installation Instructions
Securing the Oven in the Opening
Sliding the Oven Into
the Opening
a. Loop (do not tie) a 36" (91 cm) string around
the conduit before the oven is slid into place.
This will keep the conduit from falling behind
the oven.
itt
Pull out on string
loop while push-
ing the oven into
the cabinet
Ci
SSSSSSSSSSSSSsssssssss
b. Lift oven into cabinet cutout using the oven
opening as a grip. Carefully push against
oven front frame. Do not push against outside
edges.
c. As you slide the oven back, pull the string so
that the conduit will lie on top of the oven ina
natural loop.
d. When you are sure the conduit is out of the
way, slide the oven 3/4 way back into the
opening. Remove the string by pulling on one
end of the loop.
Drilling the Pilot Holes and
Mounting the Oven
C2
NOTE: Before drilling the pilot holes, make
sure the oven is pushed as far back into
the opening as it will go
and centered.
&
a. Drill through the mounting holes (top and
bottom) of the side trim, for the #8 screws
provided.
The screws must
be a minimum of
1/4" (0.64 cm) from
the front
of the cutout.
tions (Hole
Locations
may vary}
WARNING: Mounting screws
must be used. Failure to do so could
result in the oven falling out of the
cabinet causing serious injury.
b. Secure the oven to cabinet with screws pro-
vided.
NOTE: If the cabinet is particle board, you must
use #8 x 3/4" (1.9 cm) particle board screws.
These may be purchased at any hardware store.
11