GE ZET1 Installation Instructions Manual page 4

Installation Instructions
41] Cutout for Single Built-In Oven
Cutout Width 73/4" zou in ast
etree 72.7 cml >| Mex) Junetion Cabinet Width 30" (76.2 cml
Box Location
(junction box ;
may be located in Recommended
adjacent cabinet) Cutout Location
Allow 11/16" from Floor 32 1/2" (82.6 cm)
(1.75 cm) for
overlap of _| s-opening | || Pa - Cutout Depth 23: 1/2" (59.7 cm) Min.
side edges etween
I id n * n *
of cutout Walls Must 3 U4 Min, 22'(559eml Cutout Width 28 1/2" (72.4 cm) Min.
se | |] EER] encom a
285/8 (72.7 cm] Max.
(72.4cm) Ade i
Wide Sa t Cutout Height 27 1/4" (69.2 cm} Min.
av
=
ee NS
27 5/16" (69.4 cm) Max.
(S3.3cm) .
es Allow 1" (2.5 cn): ' (fr
-... minimum for
overlap of oven
top and 1%'
(3.2 cm} overlap
of oven bottom of
—— ~~ cutout
Cabinet
Width
Allow a minimum
of 21" (53.3 cm) for
clearance to adjacent
corners, drawers, walls,
etc. when
door is open
30" (76.2 crm
ey
Recommended cutout
location from floor 32
1/2" (82.6 cm)
a
If the cabinet does not have a solid bottom, two
braces or runners must be installed level with
the bottom of the cutout to support the weight
of the oven. For single ovens, the runners and
braces must support 200 Ibs. (90 kg).
NOTE: If marks, blemishes or the cutout
opening are visible above the installed
oven, it may be necessary to add wood
shims under the runners and front trim
until the marks or opening are covered.
Suitable
Bracing
Side by Side Installations
Install two wall ovens in separate cutouts.
Allow 2" (5.1 cm) min. between cutouts.
Cutout - 2" (5.1 cm] Cutout -
Observe all Min. Observe all
dimensions | ®) dimensions
and and
requirements. requirements.
Runners
to Support
NOTE: If the cabinet does
not have a front frame and the
sides are less than 3/4" (1.9 cm)
thick, shim both sides equally to
establish the cutout width.
&
¢ Installa
solid bottom
or 2" x4'
(5cmx 10 cm) or
equivalent runners
level with bottom
of cutout
tel \\
(54.9 cm}
Over Centerline
of Cabinet
The solid bottom or runners must be level with
the bottom of the cutout, or the bottom trim
may not install correctly and then interfere
with the door opening.
This oven is not approved for stackable
installation.