Viessmann VITOCELL 140-E Installation And Service Instructions Manual page 34

Heating water buffer cylinder with Vitotrans and with Solar-Divicon
Fitting the cover strips
3.
C
A
B
Fig. 31 Example: Vitocell 140-E, type SEIC, 750 l
A Groove for separating the cover strip
Cover strip, lower part
B
1. Screw the nuts onto the bolts.
2. Fit the front section of the Vitotrans thermal insula-
tion.
3. Prepare and fit the front cover strip in accordance
with the following table.
Fitting the cover strip
Cylinder capacity
600 l
750 l
950 l
34
1.
2.
With Vitotrans and Solar-Divicon
Do not fit a cover strip.
Shorten part
C
Fit without shortening part
5.
4.
D
6.
C Cover strip, upper part
Type plate
D
4. Fit the rear cover strip to the thermal insulation.
5. Affix type plate
D .
6. Tap the thermal insulation towards the front. This
reduces the gap to the fitted modules.
to 300 mm and fit.
.
C