Roland HandSonic 10 Service Notes
Roland HandSonic 10 Service Notes

Roland HandSonic 10 Service Notes

Hide thumbs Also See for HandSonic 10:

Advertisement

Quick Links

Mar. 2006
HPD-10

Table of Contents

Specifications .....................................................................2
Location of Controls .........................................................4
Location of Controls Parts List........................................5
Exploded View (1).............................................................6
Exploded View (1) Parts List ...........................................7
Exploded View (2).............................................................8
Exploded View (3).............................................................9
Wiring Diagram...............................................................10
Parts List ...........................................................................11
Checking the Version Number......................................13
User Data Save and Load...............................................13
Factory Reset Instructions..............................................13
System Software Updating Instructions ......................13
Test Mode .........................................................................14
Copyright © 2006 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written
permission of ROLAND CORPORATION.
Block Diagram .................................................................21
Circuit Board (MAIN BOARD 1/2)..............................22
Circuit Board (MAIN BOARD 2/2)..............................23
Circuit Diagram (MAIN BOARD 1/4).........................24
Circuit Diagram (MAIN BOARD 2/4).........................26
Circuit Diagram (MAIN BOARD 3/4).........................28
Circuit Diagram (MAIN BOARD 4/4).........................30
Circuit Board (PANEL BOARD 1/2)............................32
Circuit Board (PANEL BOARD 2/2)............................33
Circuit Diagram (PANEL BOARD) ..............................34
Circuit Board (SENSOR BOARD) .................................36
Circuit Diagram (SENSOR BOARD) ............................37
Error Messages ................................................................37
17058413E0
SERVICE NOTES
Issued by RJA
Printed in Japan (0440) (SC-KWS)
HPD-10

Advertisement

Table of Contents
loading

Summary of Contents for Roland HandSonic 10

  • Page 1: Table Of Contents

    Circuit Diagram (SENSOR BOARD) ......37 System Software Updating Instructions ......13 Error Messages ..............37 Test Mode .................14 Copyright © 2006 ROLAND CORPORATION All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION. 17058413E0...
  • Page 2: Specifications

    Mar. 2006 HPD-10 Specifications HPD-10: HandSonic 10 Power Supply 10 inches, 10 sections, Pressure-Sensitive AC Adaptor (DC 9 V) Instruments Current Draw 350 mA Kits Dimensions 323 (W) x 427 (D) x 75 (H) mm 12-3/4 (W) x 16-13/16 (D) x 3 (H) inches...
  • Page 3 Mar. 2006 HPD-10...
  • Page 4: Location Of Controls

    Mar. 2006 HPD-10 Location of Controls fig.location.eps 12 13 14...
  • Page 5: Location Of Controls Parts List

    Mar. 2006 HPD-10 Location of Controls Parts List PART CODE PART NAME DESCRIPTION Q’TY 04129545 TOP PANEL 04129589 RUBBER SW 03565789 M R-KNOB LF-ELA BLK 03125589 M R-KNOB MF-ELA BLK/LCG 73129523 PANEL BOARD ASSY includes the LCD 04129445 ESCUTCHEON D-BEAM CONTROLLER 03126134 LED(INFRARED) TLN233(F)
  • Page 6: Exploded View (1)

    Mar. 2006 HPD-10 Exploded View (1) fig.bunkai.eps_90...
  • Page 7: Exploded View (1) Parts List

    Mar. 2006 HPD-10 Exploded View (1) Parts List PART CODE PART NAME DESCRIPTION Q’TY 04129423 PAD HOOP 04124990 PLAYING PLATE 01900234 CUSHION 01900245 PRESSURE SHEET SENSOR 73129489 SENSOR BOARD ASSY 03125589 M R-KNOB MF-ELA BLK/LCG 03565789 M R-KNOB LF-ELA BLK 04129545 TOP PANEL 04129412...
  • Page 8: Exploded View (2)

    Mar. 2006 HPD-10 Exploded View (2) fig.heimen-top-bottom-rear BOTTOM REAR PART CODE PART NAME DESCRIPTION Q’TY 02126156 SCREW M3X10 HEX SOCKET HEAD CAP TAPTITE P 40011245 SCREW 4X12 BINDING P-TITE FE NI 40238145 SCREW M5X12 TRUSS BZC 40340812 SCREW M3X10 PAN MACHINE W/SW BZC...
  • Page 9: Exploded View (3)

    Mar. 2006 HPD-10 Exploded View (3) fig.heimen-view1-3 VIEW 1 VIEW 2 VIEW 3 PART CODE PART NAME DESCRIPTION Q’TY 40011245 SCREW 4X12 BINDING P-TITE FE NI 40011278 SCREW 3X8 BINDING TAPTITE P FE ZC...
  • Page 10: Wiring Diagram

    Mar. 2006 HPD-10 Wiring Diagram fig.wiring-e.eps_95...
  • Page 11: Parts List

    Mar. 2006 HPD-10 Parts List fig.part1e Due to one or more of the following reasons, SAFETY PRECAUTIONS: parts with parts code ******** cannot be supplied as service parts. The parts marked have safety-related characteristics. Use only listed parts for replacement. •...
  • Page 12 Mar. 2006 HPD-10 ENCODER 03231912 ROTARY ENCODER W/SW R-ENCODER EVQB1SZ1720B EN1 on PANEL CONNECTOR 13369664 CONNECTOR S4B-PH-K-S(LF/SN)(4P) CN3 on MAIN 02012056 CONNECTOR CONNECTOR 28FMN-BTK-A CN5, 6 on MAIN 02564678 CONNECTOR 12FE-ST-VK-N CN4 on MAIN WIRING, CABLE 04129578 BAN CARD BNCD-P=1.25-K-12-240 03671856 BAN CARD BNCD-P=1.00-K-28-60...
  • Page 13: Checking The Version Number

    Mar. 2006 HPD-10 Checking the Version Factory Reset Instructions Number While holding down [EFFECT], [3 (STEEDRUM)] and [EDIT] at the same time, turn on the power switch. This resets all parameters to the original factory version. You can not use Undo Hold down [EFFECT], [3 (STEELDRUM)] and [EDIT] until the following after executing this function.
  • Page 14: Test Mode

    Mar. 2006 HPD-10 Test Mode When the receiving is completed, the message of “Updating: 1/8” appears and the writing of the receiving data begins. The [KIT] LED is turned off. The [EFFECT] LED is turned on. Items Required • PD-8 x 2 After writing data for one file is completed, the message of “Updating: ok 1/8”...
  • Page 15 Mar. 2006 HPD-10 Details for Tests (3) MIDI Test [3. MIDI] Connect MIDI IN and MIDI OUT with a MIDI cable. (1) Version [1. Version] Signal flow is detected and the following message appears in the LCD display. Check the version. fig.test04.eps_35 fig.test01.eps_35 Press [1 (CONGA)], [2 (TABLA)] and [3 (STEELDRUM)] to check the each...
  • Page 16 Mar. 2006 HPD-10 (4) Foot Switch Test [4. Foot Switch] (5) Ext Trigger Test [5. Ext Trigger] Connect the white plug and red plug of PCS-31 to two each FS-5U, and Connect the white plug and red plug of PCS-31 to two each PD-8, and connect the black plug to the EXT TRIG/FOOT SW jack of the HPD-10.
  • Page 17 Mar. 2006 HPD-10 (6) Sound Test [6. Sound] Connect the oscillator or the portable CD player to the MIX IN connector with a stereo cable, and put in the audio signal. Check the input signal comes out from the OUTPUT connector without changing.
  • Page 18 Mar. 2006 HPD-10 (8) Encoder/LCD Test [8. Encoder & (9) Pad Pressure Test [9. Pad Pressure] LCD] The test program automatically checks whether or not the pressure value changes. Gradually rotate the Encoder to the right (clockwise). Rotate the knob If the test passes, the test program advances to the next section automatically.
  • Page 19 Mar. 2006 HPD-10 (11)D-Beam Test [11. D-Beam] The test program automatically checks whether or not the D-Beam value is 0 (checks the optical receptor circuit when the emission of D-Beam light is The test doesn’t return OK if two or more pads respond simultaneously. stopped).
  • Page 20 Mar. 2006 HPD-10 (12)Factory Reset [12. Factory Reset] fig.test39.eps_35 Press [4 (DRUMS)] to execute Factory Reset and return the settings to their factory default values. fig.test40.eps_35 If any test item has failed to return OK, the following message appears in the display.
  • Page 21: Block Diagram

    Mar. 2006 HPD-10 Block Diagram fig.** (fig.block.pdf_85)
  • Page 22: Circuit Board (Main Board 1/2)

    Mar. 2006 HPD-10 Circuit Board (MAIN BOARD 1/2) fig.main-components.eps_60...
  • Page 23: Circuit Board (Main Board 2/2)

    Mar. 2006 HPD-10 Circuit Board (MAIN BOARD 2/2) fig.main-foil.eps_60...
  • Page 24: Circuit Diagram (Main Board 1/4)

    Mar. 2006 HPD-10 Circuit Diagram (MAIN BOARD 1/4) fig.** (fig.main1.pdf left side) R212 RA13 RA14 RA12 AVDD/VREF R215 AVSS RA16 RA11 RA15 IC35 IC35 R218 RA17 R219 R221 R195 IC35 RA22 RA18 RA23 R196 R192 C241 IC35 R193 R194 RA19 CKSEL VPP/MODE2 MODE1...
  • Page 25: Circuit Diagram (Main Board 2/4)

    Mar. 2006 HPD-10 Circuit Diagram (MAIN BOARD 2/4) fig.** (fig.main2.pdf left side) IC18 IC21 R122 RA31 C165 C119 C106 C109 C111 R104 R101 C170 IC13 IC14 C110 C180 C120 IC12 C173 C113 R105 R102 C171 IC13 IC14 C179 RA24 RA32 C176 R186 RA25...
  • Page 26: Circuit Diagram (Main Board 3/4)

    Mar. 2006 HPD-10 Circuit Diagram (MAIN BOARD 3/4) fig.** (fig.main3.pdf left side)\ C183 C169 IC25 IC26 RA26 RA27 C174 C163 R119 C168 R163 IC27 R162 IC25 R145 R146 R126 C175 R125 R127 R120 IC25 R147 R148 R121 IC25 R149 R128 R150 IC24 R129...
  • Page 27: Circuit Diagram (Main Board 4/4)

    Mar. 2006 HPD-10 Circuit Diagram (MAIN BOARD 4/4) fig.** (fig.main4.pdf left side) C201 C203 C202 C198 R179 R180 R175 R176 R183 R177 R178 RA28 IC33 IC33 C226 IC33 R198 R199 R201 R202 R203 R204 R205 C216 C224 C200 C217 C195 C193 C191 C189...
  • Page 28: Circuit Board (Panel Board 1/2)

    Mar. 2006 HPD-10 Circuit Board (PANEL BOARD 1/2) fig.panel-components.eps_60...
  • Page 29: Circuit Board (Panel Board 2/2)

    Mar. 2006 HPD-10 Circuit Board (PANEL BOARD 2/2) fig.panel-foil.eps_60...
  • Page 30: Circuit Diagram (Panel Board)

    Mar. 2006 HPD-10 Circuit Diagram (PANEL BOARD) fig.** (fig.panel.pdf left side) LCD1 LED16 LED20 C155 LED17 LED19 LED18 LED14 LED12 LED11 LED10 LED2 LED5 LED15 LED13 LED8 LED4 LED7 LED6 LED3 LED9 SW13 SW15 SW17 SW10 SW11 SW11 SW14 SW16 SW18 SW12 SW12...
  • Page 31: Circuit Board (Sensor Board)

    Mar. 2006 HPD-10 Circuit Board (SENSOR BOARD) fig.sensor.eps_65...
  • Page 32: Circuit Diagram (Sensor Board)

    Mar. 2006 HPD-10 Circuit Diagram (SENSOR BOARD) fig.sensor-kairo.eps_40 Error Messages midi offline! MIDI Cable was disconnected, or Communication with external MIDI device was interrupted. Check the MIDI connections and cables. midi buf full! Too much MIDI messages were received at once and could not be processed correctly.
  • Page 33 Mar. 2006 HPD-10...
  • Page 34 Mar. 2006 HPD-10...
  • Page 35 Mar. 2006 HPD-10 MEMO...

This manual is also suitable for:

Hpd-10

Table of Contents