Installation; Turning Off The Heater - Master SC23QZ-R Manual

Gas Valve
Gas Tap (Not Included)
Pipe (Not Included)
Gas Regulator
Protection Baffle
Cylinder (Not Included)

INSTALLATION

1. Put the cylinder into the gas heater
2. Install the protection baffle to make sure the cylinder cant' move
3. Connect the pipe to the gas valve with cap (make sure no leakage)
4. Connect another side of the pipe to the regulator with cap (make sure no leakage)
5. Open the gas tap before using the heater, and close the gas tap after using.
LIGHTING HEATER
Before connecting the regulator to the gas cylinder. Cheek whether there is a rubber washer on
the regulator, and the washer must be in good condition.
Connect the regulator to the gas cylinder by turning the hand wheel anticlockwise.
Open the gas cylinder by turning the gas cylinder valve anticlockwise. Turn the gas control knob
on the heater to setting 1 (fig 4).
Press the control knob down and hold in the pressed condition. This will allow gas to flow to the
pilot and center burner.
While holding the control knob in the pressed position push the piezoelectric ignition (fig 4)
button 2 or 3 times. Each time you strike this piezoelectric ignition you will hear a clicking sound
as well as see a spark on the pilot burner.
Once the pilot has lit, continue holding the gas control knob in the pressed position for a further
10 to 15 seconds thus activating the flame failure safety device.
The pilot and center burner should remain alight.
You may now adjust the heater setting to Low/Med/High as required.

TURNING OFF THE HEATER

To turn off the heater, turn the control knob to position 1 and close the gas cylinder valve by