Table of Contents
Advertisement
The "Word Finishing'' People
21
-Do not attempt to laminate adhesives which are marked "Fiammable."
-Do not laminate glitter and/or sharp metallic objects. Damage to the heat
rollers may result.
1. Remove the film from the laminator following the procedure outlined in
steps 1 through 4 of the section entitled LOADING AND THREADING FILM.
Method Using Film Threading Card.
2. Set the Motor Run switch to the "Stop" position.
3. Set the Speed Control at the "Fast" position.
4. Set the ON/STANDBY switch to the "On"
I
position.
5. Allow the laminator to heat until the Ready lamp illuminates.
6. Set the ON/STANDBY switch to the "Standby"
(
1
)
position and
disconnect the attachment plug from the receptacle.
7. Remove the top roll of film.
8. Place the safety shield in its full upright position.
9. Remove the feed table.
10. Rub the top and bottom heat rollers with a mildly abrasive pad, such as a
3M™ Scotch Brite™ pad. Rotate the rollers using the pad to avoid direct
contact.
11. Install the feed table.
12. Lower the safety shield.
13. Follow the procedure entitled FILM LOADING AND THREADING.
Method Using Film Threading Card.
Advertisement
Table of Contents
