GBC GBC4250 Operating Instructions Manual page 14

14
The "Word Finishing'' People
8. Place the roll of film on a clean stable surface in front of the laminator. The
roll of film must be positioned to unroll in same direction as shown on
threading diagram (figure 4) or threading label located on laminator.
9. Unroll enough film to
contact and completely
cover the pre-existing
film laying on the
bottom heat roller. Lay
the leading edge of film
on the tacky edge of
the pre-existing film
(see figure 9).
10. Replace bottom
film guide.
11. Install the bottom
supply roll.
12. Remove top supply roll from laminator and remove film roll core from
supply roll shaft. Observe that both core clips are still located on the supply
roll shaft. Check removed core if either core clip is missing.
13. Slide new film roll onto supply roll shaft. Compare film roll orientation of
newly installed roll with threading diagram (figure 4) or threading label
located on laminator.
14. Replace top supply roll. Newly installed roll must unroll in same direction
as shown on threading diagram (figure 4) or threading label located on
laminator.
15. Unroll enough film to contact and completely cover the pre-existing film
laying on the top heat roller. Lay the leading edge of film on the tacky edge
of the pre-existing film.
16. Lower the shield to full down position. Install feed table.
17. Set motor speed control at slowest setting. Position ON/STANDBY
switch to "On"
I
setting. Set motor RUN/STOP switch to "Run" setting.
18. Observe the film as it is pulled through the laminator to assure that the
remaining pre-existing film and the new film are advancing concurrently. Any