Table of Contents
Advertisement
10
The "Word Finishing" People
Adhesive will deposit on the heat rollers if either only one roll of film is used,
different widths of film are used simultaneously, or either roll is loaded with
the adhesive side contacting the heat rollers. Refer to the section entitled
CARING FOR THE GBC425Q LAMINATOR for instructions regarding
removal of accumulated adhesive.
FIGURE 5
The adhesive side of the film is on the inner surface of the web (see figure
5). The shiny side of clear film must contact the heat rollers. The dull side of
clear film contains the adhesive. Use extreme caution when loading
delustered (matte) film because both sides appear dull.
Always change the top and bottom supply rolls at the same time. Near the
end of each roll of GBC laminating film is a label stating "Warning-End of
Roll." The appearance of this label on either the top or bottom roll requires
that new rolls of laminating film be installed as soon as the item presently
being laminated completely exits the rear of the laminator. Do not introduce
any additional items into the laminator when the warning label appears on
either the top or bottom roll.
Method Using Film Threading Card
The following procedure uses the film threading card provided with new rolls
of GBC film. The laminator should be cooled to touch before proceeding.
1. Set the ON/STANDBY switch in the Standby Ci) position. Remove feed
table.
2. Cut remaining top and bottom film webs between supply rolls and heat
rollers. Be careful not to cut the heat rollers.
3. Raise shield to upright position.
Advertisement
Table of Contents
