Omega C760 Instruction Manual page 6

Assembly and Installation
USING YOUR C760 LAMPHOUSE ON OMEGA C760 ENLARGERS
girder.
At the rear of the lamphouse are three holes, two on
one side and one on the other side. These holes are for
attaching the black grooved glides. There are three
Phillips head screws used to attach the glides to the
lamphouse, using a Phillips screwdriver. Place the
screws into the glides with the grooved end closest to
the head of the screw. Screw each glide into place in
the rear of the lamphouse. Tighten the screws to make
sure the glides are securely fastened to the lamphouse.
Place the lamphouse on the Film and Lens Stage
Module so that the glides fit into the corresponding
key-shaped openings on the mounting plate. When the
lamphouse is in position, tighten the locking screws
until they make contact with the rear of the lamp-
house. Note: Refer to alignment section of your C760
Enlarger Instruction Manual for use of these locking
screws for optical alignment.
1. Before starting, make sure that all power cords
are unplugged from timers, voltage stabilizers or
electric outlets.
2. To replace an existing condenser lamphouse,
unscrew the four slotted screws which attach
the lamphouse to the carriage and lifting lever.
Carefully remove and store the lamphouse and
all of its parts for possible future use. KEEP THE
FOUR SLOTTED SCREWS as they will be needed
to attach the C760 Dichroic Lamphouse.
3. To replace an older Dichroic Lamphouse,
carefully remove the Phillips head screws and
lamphouse retainers as they will be used again.
When ready to mount the C760 Dichroic
Lamphouse, the chassis should look as
illustrated to the right.