Omega C760 Instruction Manual page 9

Modular dichroic and universal vari/con™ diffusion lamphouse systems
Hide thumbs Also See for C760:
Table of Contents

Advertisement

5. Install the right side mounting hardware (right
7. Repeat the operation described in Step '5" on
side when you are facing the enlarger) which
the LEFT side of the lamphouse.
consists of a knurled screw and a black plastic
tab mounting bushing. Secure the hardware but
8. To align the lamphouse, place a film carrier for
DO NOT TIGHTEN.
the largest size negative you will be using on the
film stage of the enlarger. Proper alignment en-
sures even illumination.
6. Position the enlarger lifting arm lever on the left
side and use the slotted screw, star washer, and
flat washer in combination to make up the lifting
arm adjustment assembly. The star washer
should go next to the arm, followed by the flat
washer and then by the slotted screw.
Install the screws in the tapped hole at the front
end of the lamphouse mounting arm. Secure but
DO NOT TIGHTEN. Then move the lifting arm so
that the lifting lever screw is approximately in
the center of the oval cutout on the arm. Now
tighten this screw. This adjustment controls the
amount of lamphouse lift and can be changed
later if desired.
9. Attach the lamphouse power cord to an Omega
timer or directly into the a standard AC outlet. If
the C760 Lamphouse
is attached to a timer, turn
on the switch. If the lamphouse is connected
directly to an AC outlet, it will go on
automatically.
10. Position your C760 Lamphouse so that the light
seal at the bottom comes in contact with the
film carrier squarely. Once the lamphouse is in
its correct position, simply tighten the hexagonal
nut and all of the positioning screws on the lifting
lever arm. Turn off the power.
11. Finally, you might want to check the alignment
of your enlarger's film carrier stage, lens stage
and baseboard. All of these stages should be
completely parallel. For precise determination of
alignment, Omega provides a special Enlarger
Alignment Too!
(Cat. No. 479-027)
which is
both simple to use and precise. For more infor-
mation, contact your local dealer or Consumer
Service, Omega, Woodside,
New York 11377.

Advertisement

Table of Contents
loading

Table of Contents