Omega C760 Instruction Manual page 8

USING YOUR C760 LAMPHOUSE WITH OMEGA B66 OR OMEGA B22 ENLARGERS
Note: The following operations can be performed most conveniently if you set your enlarger on the floor or ona
low table so that the top of the girder is about chest level. When the enlarger carriage is at a convenient height,
tighten the carriage locking knob to lock the carriage in position.
1. Disconnect all power cords before starting.
2. Remove the existing condenser lamphouse from
your enlarger chassis following the instructions
given in the instruction manual for your par- :
ticular model. Be careful with condenser lenses H
and enlarging bulbs to avoid damage or breaking.
Store all parts carefully for possible future use.
keep the bracket from moving.
i
BS
4. Position the C760 Lamphouse with the mounting
bracket attached in the approximately correct
position on the film stage of the enlarger. Then,
spread the mounting arms slightly so that they
slide over the Phillips head screws at the top of
the carriage side plates. You will have to exert
some force to spread the arms sufficiently to
clear the heads of the screws.