Table of Contents
Advertisement
Special Light Attenuators
To provide more complete control over light output,
interchangeable light attenuators are supplied and
can be used to reduce the light by one, two or three
fistops. This permits using optimum aperture/
exposure time combinations for convenient exposure
or use of creative controls such as dodging and
burning-in. (Page 12)
Attenuators supplied with dichroic lamphouse and
available as an optional accessory (Cat. No. 429-330)
for diffusion lamphouse.
Built-In Infra-Red and Ultra-Violet Filtration
Built-In Solid State Power Supply
Eliminates the need for external transformer or power
supply. You can simply connect your C760 Lamp-
house to an Omega enlarging timer or to any con-
venient standard 110V 60Hz AC outlet, or 240V 50Hz
outlet depending on unit purchased.*
*Recommended Optional Accessory: For the most
precise, consistent color printing regardless of power
fluctuations, the use of the solid state Voltage
Stabilizer (Cat. No. 403-730) is strongly recommended
for the 110V 60Hz only. The 240V 50Hz units have the
stabilizer built into the lamphouse.
Flow-Through Convection Cooling System
A combination of cooling fins and light-traps provides
convection cooling for greater comfort and for
reduction of heat on the negative, thus helping prevent
negative buckling.
Convertible for Slide Duplication
(Dichroic Lamphouse Only)
By simply inverting your C760 Dichroic Lamphouse on
the baseboard, you have an ideal lightbox with
complete color control for duplicating color sides. You
can use the full range of CC settings for color
correction or to create unusual effects. (Page 16)
Unpacking Your Lamphouse
1. Open the shipping container carefully and gently
remove the contents. Check all items against the
enclosed check list and do not discard any
packing materials until you have accounted for
all components and mounting hardware. Save
the cartons for possible future use: they are
designed to give your equipment maximum
protection during storage and shipment.
2. As noted eariler, your C760 Lamphouse can be
used with all current and recent medium-format
Omega enlargers. The only difference is in the
brackets that are used to attach the lamphouse
to the enlarger chassis. Mounting hardware and
brackets are included for C760, C700, B600 and
Concept Six enlargers. If you are adding a C760
Lamphouse to your present C67, B66 or B22
enlarger, use the appropriate Mounting Kit
described on page 5.
3. If any parts are missing, contact your local
dealer or: Consumer Service at the address
closest to you listed on page 3.
Advertisement
Table of Contents
