Table of Contents
Advertisement
ENGLISH
TROUBLESHOOTING
%
~ The AC power cord is disconnected.
* Connect the cord securely.
- Poor connection at the wall socket or the wall socket is
inactive.
+ Check the wall socket using a lamp or another appliance.
NO SOUND FROM THE SPEAKERS
— Speaker cables are disconnected.
« Check the speaker connections.
~ Volume is too low.
« Adjust the volume.
- Speakers are not switched on.
« Press the SPEAKER switchn to switch on the speakers.
NO SOUND IS HEARD, EVEN WHEN INPUT SELECTION
IS MADE
- The MUTE button is pressed.
¢ Press MUTE again to cancel the MUTE function.
—- Volume is too low.
;
¢ Adjust the volume.
- Connections between the components are incorrect.
« Make connections correctly.
THE REMOTE CONTROL UNIT DOES NOT OPERATE
~ No batteries loaded or dead batteries.
* Replace the batteries.
- The remote sensor is obstructed.
* Remove the obstacle.
STATIONS CANNOT BE RECEIVED
- No antenna connected.
« Connect an antenna.
- The desired station frequency is not tuned in.
* Tune in the desired station frequency.
~ Antenna in wrong position.
¢ Move antenna and retry turning.
— Surrounding area causing interference.
« Lengthen or elevate antenna.
PRESET STATIONS CANNOT BE RECEIVED
-
~ An incorrect station frequency has been memorized.
+ Memorize the correct station frequency.
— The memorized stations are cleared.
* Memorize the stations again.
12
« Change the position of the antenna.
CONTINUOUS HISSING NOISE DURING FM
RECEPTION, ESPECIALLY WHEN A STEREO
BROADCAST !S RECEIVED
~ Weak signal.
¢ Change the position of the antenna.
« Install an outdoor antenna. Use an antenna with 3, 4 or 5
elements if the broadcast station is far away.
CONTINUOUS OR INTERMITTENT HISSING NOISE
DURING AM RECEPTION, ESPECIALLY AT NIGHT
- Noise is caused by motors, fluorescent lamps or lightning,
etc.
;
* Keep the receiver away from noise sources.
¢ Install an outdoor AM antenna.
A_HUM CAN BE HEARD DURING AM RECEPTION
- The AC power cord may be too close to the AM loop
antenna or the antenna wire.
* Position the AC power cord away from the antenna wire
and the AM loop antenna.
* Adjust the position of the AM loop antenna.
OTHER SYSTEM COMPONENTS DO NOT REACT TO
REMOTE CONTROL COMMANDS
~ DIG! LINK I connections are not made properly.
« Make proper DIGI LINK I connections.
Advertisement
Table of Contents
