Ferris 300e Operator's Manual page 11

• Battery Icon (A) - Displays current State of Charge
(SoC).
NOTE: When you charge the battery, the Battery icon
displays charge progress.
• Center Window (B) - Displays estimated run time. *
• Wheel Icon (C) - Tap to cycle through three ground
speed ranges (Low, Medium, High).
• Blade Icon (D) - Tap to cycle through three fixed mower
blade speeds (Low, Medium, High).
• Menu Bar (E) -
• Home Icon - Tap to access Main Drive Screen.
• Gear Icon - Tap to access Settings screen. See
Settings Screen.
• Hourmeter (F) - Displays total number of unit operating
hours.
NOTE: The Menu Bar and Hourmeter display on all screens.
NOTE: * Estimated run time will be affected by ground speed
and blade speed. For best run time, use the lowest ground
speed and blade speed that the mowing conditions will
permit.
11
Drive Screen - Interlocks (Figure 12)
The center section of the screen (A) shows the three Interlock
requirements:
• The operator must be in the operator seat, and
• The parking brake must be engaged, and.
• The ground speed levers must be moved outward to the
START / PARK position.
Each interlock icon turns blue when that requirement is met.
(In this example, the operator is not in the operator seat.)
When all three interlock requirements are met, the center
section of the screen switches to estimated run time. See
Drive Screen - Main.
12
Drive Screen - System Fault Alert (Figure 13)
An alert symbol in the center section of the screen (A) informs
the operator that a system fault has occurred. Tap the alert
symbol to identify the system fault. See Pop-Up Alerts. Also
see Trouble Codes in the Troubleshooting section.
Once the system fault is resolved, shut down and restart the
unit to clear the alert.
11