Kohler Underscore K-1835-H2-0 Installation And Care Manual page 6

Install the Whirlpool (cont.)
Cut the Pump Banding Straps
IMPORTANT! This step is necessary to make the whirlpool operate more quietly.
Cut the two pump banding straps from the whirlpool pump with a tin snips.
NOTE: Do not raise the pump higher than it was before cutting the straps. If the pump is raised too high,
it will not prime properly. Make sure the rubber isolation feet are in place.
Install the Plumbing
Insert the drain tailpiece into the trap. Secure the drain tailpiece to the trap.
Install the faucet valve.
Check the drain connections for leakage.
If needed, install the grab bars according to the instructions.
1194657-2-B 6 Kohler Co.