Sony HANDYCAM DCR-HC30 Operation Manual page 105

yOU ]lave recorded afterwards is not output from tile
speaker. Check the sound by using a TV.
Insert a recorded cassette into your
camcorder.
Slide the POWER switch repeatedly to
select the PLAY/EDIT mode.
3 Touch E]_ (play/pause) to play the
tape.
4 Touch _ (play/pause) again at the
point where you want to start
recording the sound.
The playback pauses.
Touch _.
Touch [MENUI.
7 Touch []_/[]_ to select _ @ (EDIT/
PLAY), then touch _.
"lbuch []_/[]_ to select lAUD DUB
CTRL], then touch [_.
A0D EYOB CT_
Touch [AUDIO DUB I.
A green _ II mark appears on the LCD
screen.
160m_ I ¢= 00000e0
_UD BUS CTEL
1@Touch _ (play) and start playing
back the audio you want to record at
the same time.
A red _ mark remains on the LCD screen
while recording sound.
The new sound is recorded in stereo 2 (ST2)
during the playback of the tape.
1 1Touch [lq (stop) when you want to
1
stop recording.
[k_ dub on other scenes, repeat steps 3 and 4
to select scenes, then touch [AUDIO DUB].
12T
ouch [_, then E_. __,
To set the end point for audio dubbing
During playback, press ZERO SET MEMORY
on the Remote Commander at the scene at
which you want to stop audio dubbing. Then,
perform steps 4 to 10. The recording stops
automatically at the selected scene.
0 Note
• YOU can only record _dditiona] audio over a tape
recorded on your camcorder. The sound may
deteriorate when you dub audio on a tape recorded
on od/er camcorders (including other DCR-HC30/
HC40 camcorders).
-_continued
Dubbing/Editing 105