Charging The Battery Pack 3; Preparing The Chassis 3 - THUNDER TIGER 6540-F Instruction Manual

1
CHARGING THE BATTERY PACK
(Battery and Charger are not included in the kit.
a. Once the battery ready to be charged, first plug the AC quick charger into the outlet of AC power source, and then connect the
battery input/output harness to the charger.
b. Continued to monitor the battery as it is being charged. As soon as the battery is fully charged, disconnect the battery. from the
charger plug (Over-charging or charging incorrectly using inadequate chargers may cause the battery pack to become dangerously
hot).
c. Make sure that the battery pack is completely discharged prior to charging. Discharging the battery pack by running the electric
motor until it slows down or using a discharger (Not included).
d. For best results, let the battery pack cool before charging. Heat may prevent the battery pack from charging to full capacity and
also decreases the performance of the battery.
a.
b.
c.
d.
1
PLUG INTO AC OUTLET.
AC
2
PREPARING THE CHASSIS
a
a. Remove the body pins (2pcs.) and detach the body.
b. Straighten antenna with a screwdriver so it is eaiser to insert into antenna tube.
c. Put the antenna wire through the antenna pipe. ( Do not cut or shorten antenna wire.!) Push the antenna pipe into the chassis
mount hole.
a.
b.
c.
45
2
CONNECT BATTERY PLUG
TO DC OUTLET PLUG FROM CHARGER.
b
2
3
AFTER CHARGE TIME EXPIRES, DISCONNECT
BATTERY PLUG FROM CHARGER PLUG.
c
)