Devices - Toshiba 23HL85 Owner's Manual

To control a DVD player:
Program the remote control to recognize the brand of your DVD
player (see "Programming the remote control to operate your other
devices" below).
The buttons shown at right will then control the DVD player.
Press DVD first.
Programming the remote control to operate
your other devices
This remote control is pre-programmed to operate most Toshiba
satellite receivers, VCRs, and DVD players. To control a non-Toshiba
device (or a Toshiba device that the remote control is not pre-
programmed to operate), you must f'ollow the steps below to program
your remote control.
1. Refer to the code tables (on pages 21 and 22) to find the
corresponding code fbr your device.
If more than one code is listed, try each one separately until you
find the one that works.
2. If you are programming the remote control to operate your:
• Cable TV converter/satellite receiver: Press CBL/SAT.
• VCR: Press VCR.
• DVD player: Press DVD.
3. While holding down DISPLAY, press the Channel Number
buttons to enter the three-digit code for your device within 10
seconds.
Note: ffyou do not enter the code within 10 seconds from step 3, or if you
enter the wrong code, this operation is canceled.
4. Point the remote control at the cable TV converter/satellite
receiver, VCR or DVD player, and press POWER to test the
code.
• If the device responds, you entered the correct code.
• If the device does not respond, repeat steps 1-4 using
another code.
5. Press TV to control the TV.
For future reference, write down the codes you used:
Cable TV converter/satellite receiver code
VCR code
DVD player code
2O
Note:
• When shipped frofR the facto_ the remote control is set to operate
your T_
• Each time you f_place the batteries, you must reprogram the remote
control.
• Some newer VCRs are capable of working on either of two remote
codes. These VCRs have a switch labeled VCR1/VCR2.
ff your VCR has this kind of switch and does not f_spond to any of
the codes for your VCR, set the switch to the other position (VCR1
or VCR2) and reprogram the remote control.
REV FF SEARCH
MUTE
POWER
DISPLAY
INPUT
Number
buttons
VOL+-
DVD
PIC SIZE
AT< 1_
DVD MENU
ENTER
-- DVD controls
DVD SKIP/SEARCH
!<,1111_t
-- CLEAR
TOP MENU
DISPLAY
Channel
Numbers
TV
DVD