Using The Remote Control; Preparing The Remote Control For Use; Installing The Remote Control Batteries; Using The Remote Control To Operate Your Other Devices - Toshiba 27D46 Owner's Manual

Using the remote control

Preparing the remote control for use

With the remote control, you can operate your TV, most cable TV
converters/satellite receivers, VCRs, and DVD players together, even if
they are different brands. In addition to operating the TV, the remote
control can operate most cable TV converters, satellite receivers,
VCRs, and DVD players, regardless of their brand. The remote control
is pre-programmed to operate most Toshiba satellite receivers, VCRs,
and DVD players. To control a non-Toshiba device (or a Toshiba device
that the remote control is not pre-programmed to operate), you must
first program the remote control. See "Programming the remote control
to operate your other devices" on the next page.

Installing the remote control batteries

To install the batteries:
1. Open the battery cover on the back of the remote control.
2. Install two "AAA" size batteries. Match the + and – signs on the
batteries to the signs on the battery compartment.
3. Close the battery cover on the remote control until the lock snaps.

Using the remote control to operate your other devices

To control a cable TV
converter/satellite
receiver:
Program the remote
control to recognize the
brand of your cable TV
converter/satellite receiver
(see "Programming the
remote control to operate
your other devices" on
page 15.) The buttons
shown at right will control
the cable TV converter/
satellite receiver.
Press "CBL/SAT" first.
J3W41121A(E)_P14-21 14
All manuals and user guides at all-guides.com
Power
Input (TV)
Mute (TV)
Channel
Numbers
CH RTN
(Channel Return)
Channel 3 4
CBL/SAT
Volume +/- (TV)
Pic Size (TV)
TV/VCR
14
Note:
The TV remote control may not operate your
VCR, DVD player, or cable TV converter.
Refer to the owner's manual supplied with
your other devices to see which features may
be available. Additionally, the remote control
for this TV may not support certain features
available on the original remote controls for
your other devices, in which case it is
suggested that you use the original remote
control for the applicable device.
Caution:
• Never throw batteries into a fire.
Notes:
• Be sure to use AAA size batteries.
• Dispose of batteries in a designated disposal area.
• Batteries should always be disposed of with the
environment in mind. Always dispose of batteries in
accordance with applicable laws and regulations.
• If the remote control does not operate correctly,
or if the operating range becomes reduced,
replace batteries with new ones.
• When necessary to replace batteries in the
remote control, always replace both batteries
with new ones. Never mix battery types or use
new and used batteries in combination.
• Always remove the batteries from the remote control
if they are dead or if the remote control is not to be
used for an extended period of time. This will
prevent battery acid from leaking into the battery
compartment.
To control a VCR:
Input (TV)
Program the remote
Power
control to recognize
Channel
the brand of your VCR
Numbers
(see "Programming the
CH RTN
remote control to
(Channel Return)
operate your other
VCR
Channel 3 4
devices" on page 15.)
Volume +/- (TV)
The buttons shown at
Pic Size (TV)
right will then control
the VCR.
Press "VCR" first.
VCR controls
14/03/2006, 3:33 PM