Calling From A Remote Phone - Sony IT-A2500 Operating Instructions Manual

Calling from a remote phone
You can call from a pushbutton (tone) phone and "pick up" new messages
recorded on the phone, using the control codes for remote operations.
However, you must first set the security code (see page 32) and turn on the
answering function.
1
Call your phone number from a pushbutton phone.
2
!
FF
Tag ee
ee ae a
ae
Hf you make a mistake, you can
ee
enn
try again, up to three times and code.
you will be disconnected. Also, if The two digits must be entered within two seconds.
you do not enter the security
code within 20 seconds, you will if there are new messages, playback starts. Otherwise the phone
be disconnected too. waits for you to enter further codes.
For details, see the "Control codes for remote operations" (page
48) section.
@ Using the toll-saver feature (TS)
When the RINGER SELECT switch is set to TS, if any new
messages are recorded, the phone answers after 3 rings. if no
new messages are recorded, it answers after 5 rings. When you
call from a pushbutton phone and hear more than 3 rings, you
know that there are no new messages. For more information, see
also "Adjusting the ringer mode" (page 18) section.
@ If the answering function ts not turned on ——_—_—_—_——_-
The phone will still answer a call after 10 rings. While you hear the
outgoing message, press # and your security code. Then press
% 0 + to turn on the answering function (page 35).