Calling From A Remote Phone; Control Codes For Remote Operations - Sony IT-A100 Operating Instructions Manual

You can call from a pushbutton (tone) phone and "pick up" new
messages recorded on the phone, using the control codes for remote
operations. The one-digit remote code to enter the remote control
function has been fixed. The remote code is attached inside the lid.
1 Call your phone number from a pushbutton
phone.
!
2 While you hear the greeting, press @ and the
i
'
remote code.
If you make a mistake, you can
a
re again within 60 anion If
The remote code must be entered within two seconds after
you make a mistake again, you you have pressed @.
will be disconnected.
If there are new messages, playback starts. Otherwise the
phone waits for you to enter further codes. For details, see
the table below.
!
@ Using the toll-saver feature (TS)
If the answering function is
If any new messages are recorded, the phone answers after 3
not turned on
rings; if not, it answers after 5 rings. When you call from a
The phone will still answer a call
pushbutton phone and hear more than 3 rings, you know that
after 10 rings and the answering there are no new messages.
function will be turned on.
oleh dco) Maelo (=t-Mh ke) mia -yaaleyc=Mo) ol:1a-h ale) aly
Play back new messages.
The phone stops every 4 minutes and waits for further codes. So, press
@®@® every 4 minutes while listening to the messages, or the phone
will be disconnected*.
Monitor sound in the room where the phone is located for 60 seconds.
(When 50 seconds has passed, short warning beeps sound for 10
seconds and the phone will be disconnected.)
Record a new greeting (between 2 and 19 seconds).
See also the "Recording a greeting" (page 19) section. Note that
recording a new greeting turns on the answering function automati-
cally.
Interrupt the current operation. The phone waits for further codes.
26 | Remote control functions