Omron F3S-B122P-L Instruction Manual page 25

F3S-B
Note:
1. The intermediate bracket and mounting screw holes are only applied to types which have a protective
height of 1050 mm or longer.
2. The master unit has an M12 connector on both ends of the sensor (for the extension cable and the se-
ries connection cable).
3. Keep the following distance for the extension cable and the series connection cable when the cable is
bent.
4. The figures on the previous pages show the L-shaped intermediate bracket (see 2-2-4) on the left side
of the F3S-B. In case the L-shaped intermediate bracket needs to be on the right side of the sensor, the
intermediate mounting bracket needs to be oriented upside down as shown the figure below. The posi-
tion of the mounting screw holes for the L-shaped intermediate bracket changes from left side to right
side. This also applies in the case of side mounting, the figures below show the rear mounting style only.
2-M5
4-M5
20
24
MOUNTING SCREW HOLES
24
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Series connection cord
of the Master unit side
and Slave unit side
Extension cord
2-M5
4-M5
20
24
MOUNTING SCREW HOLES