Sony BDV-E870 Operating Instructions Manual page 50

7
8
9
Press @.
[Auto Calibration] starts.
The system adjusts the speaker settings
automatically.
Be quiet during the measurement.
m
• Before [Auto Calibration], make sure that the
surround amplifier turns on and you install the
surround amplifier in the appropriate location. If
you install the surround amplifier inan improper
locatiom such as another room, proper
measurement will not be obtained.
• When you use the Wireless Surround Speaker
Kit (WAHT-SBP2, optional) lk)r the surround
back speakers (page 16), install the speakers in
appropriate location and turn the surround
amplifier on. To use the surround back speakers,
set [Surround Back] in [Speaker Settings] to
[Yes] (page 50)
Confirm the conclusions of [Auto
Calibration].
The speakers connected to the unit are listed
as [Yesl on the TV screen.
m
• ff measurement fails, follow the message then
retry [Auto Calibration].
• The measurement for [Subwoofcr] is always
[Yes] and [Speaker Settings] returns to the
default setting when you perform [Auto
Calibration].
Press t"/+ to select [OK] or [Cancel],
then press @.
• The measurement is OK.
Disconnect the calibration mic, then select
[OK1. The result is implemented.
• The measurement is not OK.
Follow the message, then select [OK1 to
retry.
• While the Auto Calibration function works:
do not turn off the power.
do not press any button.
do not change the volume.
do not change the function.
do not change the disc.
do not insert a disc.
do not disconnect the calibration mic.
Setting the Speakers
[Speaker Settings]
To obtain the best possible surround sound, set
connection of the speakers and their distance
from your listening position. Then use the test
tone to adjust the level and the balance of the
speakers to the same level.
1
Press HOME.
The home menu appears on the TV screen.
Press 1"-1-) to select _ [Setup].
2
3
4
5
Press ,1,14, to select [Audio Settings],
then press @.
Press '1"14, t o select [Speaker Settings],
then press @.
The [Speaker Settingsl display appears.
Press ,I,/4, to select the item, then press
®.
Check the following settings.
• [Connection]
It you do not connect center or surround
speakers, set the parameters for [Center] and
[Surround]. Since the fiont speaker and
subwoofer settings are fixed, you cannot change
them.
When you use the Wireless Surround Speaker
Kit (WAHT-SBP2, optional) for the surround
back speakers (page 16), set [Surround Back]
also.
[Front]
[Yesl
[Center]
[Yesl: Normally select this.
[Non@ Select this if no center speaker is used.
[Surround]
[Yesl: Normally select this.
[Non@ Select this if no surround speaker is
used.
[Surround Back]
[Yesl: Select this it"surround back speakers are
used.
_: Select this if no surround back speakers
is used.
50u_