Advertisement
Model EY6780
Ref. No. 6
Procedure lA-*2-*3-*4-*-5
Attachment for the adjusting screw and
Clutch handle
1. Align the O n«rk of adjusting screw with
4. Adjust the tabs of click plate to the
'A' part of the clutch case.
projection of adjusting screw.
2. Turn the adjusting screw Into driving block
5. Set the clutch handle with position 7 toward
about one rotation for clockwise direction.
A part of the clutch case.
3. Align the
OO
mark of adjusting screw with
6. Insert the clutch handle with adjusting the
'A* part of the clutch case.
tabs of adjusting screw and of click plate to
the groove of Inside clutch handle.
Ref. No. 7
Procedure IB
Removal or attachment of the battery charger.
(Removal of the battery charger.)
(Attachment for the battery charger.)
1. Remove 4 housing screws.
2. Reassemble the module block (power cord,
power transformer, and module) to housing A,
be certain that LED appears through the hole
In housing A.
3. Set the bushing for power cord to the
housing A.
NOTE : Avoid pinching lead wires, dress into
housing recess and around screw posts
etc.
4. After assembly, test for proper voltage.
Measure the battery terminals between (S) and
(-).
It Is OK, If It Is approx. 3V DC.
Advertisement
