Advertisement
Model EY6780
Ref. (to. 3B
Procedure 1A -♦ 2 -* 3B
Removal of the driving block.
Gear case block
Thrust pin
/
Thrust pin
/ Gear case B
Clutch handle
Clutch case
/ C-type spring
/
jl
-
Insert
Hammer
Bushing
Bushing
j
Qear
g
Clutch handle
1. When removing the 2 thrust pins, the driving
shaft, the ring gear and the planet gear etc.
remove one after another.
* Be careful not to lose the 12 pieces of steel
balls (05).
(Removal of the bushing.)
2. Remove the C-type spring from the bushing.
3. Set and knock the jig to remove the bushing
out rcm the clutch case.
(Attachment for the bushing.)
4. Set the bushing to the clutch case from the
side of gear case B.
Knock the jig until
the bushing Is Inserted completely.
5. Set the C-type spring to the bushing.
* Be careful not to break or deform the gear
case rib when knocking the bushing.
Advertisement
