Advertisement
Model EY6780
Removal of the revolving mechanism.
Bit holder
/
Bit holder spring
Gear case B
/
/
\ Gear
/Steel ball/
Gear case block \ case A /
(02) /Holder collars
/
\
^1 ^
ffwml
f
C*"type
ring
D
F
" flu
/Bit holder
0 f
° ==il Steel ball(02)
T
V
Bit holder bolck
\ Revolving mechanism
Clutch handle
1. Remove the C-type ring at the top of the
bit holder with snap ring pliers.
* C-type ring are lively and could be lost,
handle accordingly.
* Be careful not to lose 2 pieces of steel
balls{02) and 2 holder collars.
Ref. No. 4A
Procedure 1A -**• 2 -*> 3A -* 4A
Removal of the gear case block.
Output shaft block
0-ring
Lock pin B
Lock lever\/
Gear case B
_/ Lock pin A
Lock lever
1. Remove 4 screws for gear case A.
2. Disassemble the lock pin AB and the lock
lever.
* Be careful not to lose 2 springs attached to
the gear case A.
3. Take out the output shaft block from the
gear case B.
* Make sure to attach the O-ring with output
shaft.
4. Make sure when assembling, the lock pin AB
have their own directions.
- 3 -
Advertisement
