Table of Contents
Advertisement
6
a
Setting up the
Speakers for Dolby
Pro Logic Surround
Proper speaker positioning is essential in
order to achieve directional effects and
ditftused ambience, especially in the case of
the surround speakers. Too much direct
sound from the surround speakers can
make their presence too obvious while too
much diffusion may result in a directionless
sound image. If it is not possible to locate
the surround speakers in the preferred way,
experiment with their positioning while
keeping in mind the goal is to achieve a
diffused and enveloping, but not overly
vague, sound field.
1 Position the left and right speakers so
that they form a 45° angle with your
listening
/ viewing position. The
surround speakers should be mounted
on the side walls as shown in step 4.
JEG
a O 6
2 The two front speakers and a center
speaker should be positioned as close to
the same height as possible.
3 The center speaker should be positioned
even with, or slightly behind the front
left and right speakers.
4 If possible, mount the surround
speakers on the walls to the sides of
your listening
/ viewing area, 60 to 90 cm
above your seated position, facing each
other.
:
60-90 cm
12
(25 5/g - 35 '/2 in.)
Chapter 1: Setting Up
—ee————————
Inserting the
Batteries
Install two R6 (size AA) batteries in the
supplied remote for remote control.
1 Slide the lid to remove it.
2 Insert two R6 (size AA) batteries.
Match the + and - to the diagram in the
battery compartment.
3 Close the lid.
Battery life
You can expect the remote to operate for
about six months (using Sony SUM-3 (NS)
batteries) before the batteries run down.
When the batteries no longer operate the
remote, replace all the batteries with new
ones,
To avoid battery leakage
If you are not going to use the remote for a
long time, remove the batteries to avoid
damage caused by corrosion from battery
"leakage.
a
aT
Setting the Clock
The built-in clock shows the time in the
display even if the power is off.
Use the buttons on the unit to do this
operation.
Note
Once you set the clock, the demo mode,
that activates when the power is turned off,
is cancelled automatically.
SYSTEM
POWER > ON
DISPLAY
1 Press TIMER.
The stereo enters the clock/timer mode.
2 Press CLOCK SET.
The "AM" and hour indication begin
flashing.
'
¢
vo
1
-
et
-
od
3 Set the current hour by turning the JOG
dial until the correct hour appears.
L
4 Press ENTER/NEXT.
The minutes indication begins flashing.
flashing
sat
=
1
flashing
5 Set the current minute by turning the
JOG dial until the correct minute
appears.
flashing
© Press ENTER/NEXT.
The clock starts running and the upper
dot flashes. Use the time signal to set the
clock accurately.
The upper dot flashes for the first half of
a minute (0 to 29 seconds), and the
lower dot flashes for the last half of a
minute (30 to 59 seconds).
flashing
To check the time while power is on
Press DISPLAY a few times.
The current time is displayed for 8 seconds.
To correct the clock setting
Repeat steps 1 through 6.
Advertisement
Table of Contents
