Inserting The Batteries; Setting The Clock; Chapter 1: Setting Up - Sony MHC-550 Operating Instructions Manual

eer ee
inserting the Batteries
Insert two size AA (R6) batteries in the
supplied remote commander for remote
control.
1 open the lid.
2 Insert two size AA (R6) batteries.
Match the + and - indications to the
diagram the battery compartment.
: 3B close the lid.
Battery life
You can expect the remote commander to
operate for about six months (using Sony
SUM-3 (NS) batteries) before the batteries
run down. When the batteries no longer
operate the remote commander, replace all
the batteries with new ones.
To avoid battery leakage
If you are not going to use the remote
commander for a long time, remove the
batteries to avoid damage caused by
corrosion from battery leakage.
5 | Chapter 1: Setting up
Setting the Clock
The built-in clock shows the time in the
display. You need to set the clock to utilise
the timer-activated features of your stereo
system. The clock shows the time in the 12-
hour cycle.
1 Press CLOCK SET.
The hour and "AM" indication begins
flashing.
2 Set the current hour by pressing
TUNER/TIMER (+/-) until the correct
hour appears.
240AN
3 Press MEMORY /NEXT.
The minutes indication begins flashing.
w hie
go0AnM
4 set the current minute by pressing
TUNER/TIMER (+/-) until the correct
minute appears.
wibiw
FesAn
5 Press MEMORY /NEXT.
The clock starts running and the dot
flashes.
Use the time signal to set the clock
accurately.
SE SAM
To check the time while power is on
Press CLOCK DISPLAY on the remote
commander.
The current time appears for a few seconds
To correct the clock setting
Repeat steps 1 to 5.
in case of a power cut or when the
power cord is disconnected
12:00 AM" flashes. In this case, set the
clock again from step 1. Note that the time:
setting will be canceled as well. Therefore
you have to set it again.