Table of Contents
Advertisement
The hinges on the appliance door move when the door
is opened and closed, which could trap your fingers.
Keep your hands away from the hinges.
▶
Components inside the appliance door may have sharp
edges.
Wear protective gloves.
▶
Open the appliance door fully.
1.
Open the locking levers on the left- and right-hand
2.
hinges .
a The locking levers are open. The hinges are now se-
cured and cannot snap shut.
Close the appliance door fully .
3.
Push on the left- and right-hand side of the door
4.
cover from the outside
Remove the door cover .
5.
Lift out the door panel and set it down carefully on a
6.
flat surface.
until it is released.
If required, remove the condensate trough for clean-
7.
ing.
Open the appliance door.
‒
Tilt the condensate trough upwards and remove
‒
it.
8.
WARNING ‒ Risk of injury!
Scratched glass in the appliance door may develop
into a crack.
Do not use any harsh or abrasive cleaners or
▶
sharp metal scrapers to clean the glass on the
oven door, as they may scratch the surface.
Clean the removed door panels on both sides using
glass cleaner and a soft cloth.
Clean the condensate trough with a cloth and hot
9.
soapy water.
Clean the appliance door.
10.
→ "Cleaning agents", Page 18
Dry the door panel and refit it.
11.
→ "Fitting the door panel", Page 21
Fitting the door panel
WARNING ‒ Risk of injury!
The hinges on the appliance door move when the door
is opened and closed, which could trap your fingers.
Keep your hands away from the hinges.
▶
Components inside the appliance door may have sharp
edges.
Wear protective gloves.
▶
Note: You cannot use your appliance again until the
panel has been correctly fitted.
Open the appliance door fully.
1.
Refit the condensation trough. To do this, insert the
2.
condensate trough from above and rotate it down-
wards
.
Cleaning and servicing en
21
Advertisement
Table of Contents
