Operating Characteristics; Selecting The Clip Rate (Reel Speed) - Toro Reelmaster 2000-D 03431 Operator's Manual

Operating Characteristics

Caution
This machine produces sound levels in excess of
85dBA at the operators ear and can cause hearing
loss through extended periods of exposure.
Wear hearing protection when operating this
machine.
Practice operating the machine and become thoroughly
familiar with it. Because of its hydrostatic transmission, its
characteristics differ from many turf maintenance
machines. Points to consider when operating are the
traction drive, engine speed, and load on the cutting units.
Regulate the traction pedal to keep the engine RPM high
and somewhat constant while mowing to maintain adequate
power for the traction and cutting units. Adjust the speed
selector to maintain constant ground speed and quality of
cut. However, when on hilly terrain, do not use the speed
selector.
Follow the operating guidelines presented in this manual
and know how to operate the machine safely on all types of
terrain. Hills (or slopes) over 15 degrees should be
traversed or mowed up and down, not side to side, and hills
over 20 degrees should generally be avoided unless special
safeguards, skills, and conditions exist. Always plan well
ahead to avoid the need for sudden stops, starts, or turns. To
stop, use the reverse pedal for braking. Before stopping the
engine, disengage all controls, move the throttle to the
IDLE position, and set the parking brake.
Selecting the Clip Rate
(Reel Speed)
To achieve a consistent, high quality of cut, and a uniform
after cut appearance, it is important that the reel speed be
matched to the height of cut.
Adjust the clip rate (reel speed) as follows:
1. Verify the height-of-cut setting on the cutting units.
Using the column of the chart listing either 5 or 8 blade
reels, find the height of cut listing nearest the actual
height-of-cut setting. Look across the chart to find the
number corresponding to that height of cut.
2. Turn the reel speed control knob (Fig. 34) to the number
setting determined in step 1.
1
1. Reel speed control
3. Operate the machine for several days, then examine the
cut to ensure satisfaction with the quality of cut. The
reel speed knob may be set one position on either side
of the position indicated on the chart to account for
differences in grass condition, grass length removed,
and personal preference of the superintendent.
29
Figure 34