Table of Contents
Advertisement
EXTERNAL EQUIPMENT CONTROL SETTING
32
EXTERNAL EQUIPMENT CONTROL SETTING
External equipment control
It is the function to set the contact point output of the external equipment control mode.
• In the main screen, press [<,>(left/right)] button to select the external equipment control
category, and press [∧,∨(up/down)] button to set the contact point output.
Mode
On
When it is set to "On", it always performs the contact point output.
When you set it to "Off", it does not perform the contact point output in
Off
any case.
When it is set to "auto", the contact point output is decided according to
the user setting's external equipment logic setting value.
Auto
Auto, the ON condition and OFF condition outputs are delayed up to 90 seconds,
so keep this in mind when controlling critical equipment.
NOTE
!
Please use the corresponding function when the external equipment is actually connected.
When the external equipment is not set, please maintain "Off" status.
For the detail external equipment control condition setting, refer to the user setting - external
equipment logic setting.
Description
When set to
AI SMART CARE SETTINGS
AI Smart Care
This is a function that uses AI to manage the indoors pleasantly and save energy.
Press the [< , > (left/right)] buttons on the main screen to select the AI Smart Care item, then
press the [∨,∧ (up/down)] buttons to set.
• When the AI Smart Care runs, it is displayed on the upper left of the main screen.
• When the operation conditions do not match the AI Smart Care, the standby status is displayed
as below.
NOTE
!
• The AI Smart Care may not be displayed/run in some products.
• The AI Smart Care only runs when the product is cooling or heating.
• You may feel that cooling or heating are weak due to the power saving operation of the AI
Smart Care.
• Set the date and time precisely for the remote control and the central controller when
installing the AI engine.
• If you do not set the date and time, it may display an incorrect result value.
• The site connected to our central controller prioritizes the date and time settings of the
central controller above those of the wired remote control.
• If a model for both cooling/heating, the AI Smart Care is not available during simultaneous
cooling and heating operation.
AI SMART CARE SETTINGS
33
Advertisement
Table of Contents
