Setting The Central Control Address - LG PQRCUCA0 Owners & Installation Manual

Necessary function before using
Setting the Central-Control Address
Please set the address while using the central controller.
You don't need to set address if you don't use central controller.
PQRCUCA0
Defrost Preheat
FAN
MODE
SPEED
• If you connect the indoor unit to the central controller, you should set the network
address of the indoor unit so that the central controller could recognize it.
• The center-control address is composed of the group number and the indoor-unit
number.
Note : The remote controller displays 'HL' if central controller has locked the remote controller .
10 Simple Wired Remote Controller
Out door
Room Temp
Total on
Central Run
1
If you want to set the address on the display panel,
press both temperature control buttons (L/M) same
time for three seconds.
2
Press the temperature-increasing button to change the
group number. Press the temperature-decreasing
button to change the indoor unit number.
e.g. As shown on the left side panel, it displays 23.
Group No. : 2
Indoor Unit No. : 3
3
Set the address by pressing both temperature control
buttons again(L/M) at the same time for three
seconds.
FAN
MODE
SPEED
Group No.
Indoor Unit No.