Table of Contents
Advertisement
DLFSOAH: Installation Instructions
PARTS
Hanging bracket
Outdoor unit power cable
NOTE: Illustrations in this manual are for reference only. The actual shape of the indoor unit and parts may differ slightly.
1. Air Inlet (with air filter installed)
2. Air Flow Louver
3. Hanging Bracket
4. Display Panel
5. Drainage Pipe
6. Refrigerant Piping
7. Air Inlet
8. Air Outlet
9. Remote Controller
10. Outdoor Unit Power Cable (field supplied by installing contractor)
NOTES:
- If the outdoor unit is higher than the indoor unit, prevent rain from
flowing into the indoor unit along the connection pipe by making a
inverted trap in the connection pipe before it enters the wall to the
indoor unit. This ensures that rain drips from the connection pipe
before it enters the wall.
- Piping and the interconnecting wiring are field supplied.
- Figure 2 is a sketch. Different models may differ slightly.
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
Disconnect Switch (Factory Installed/Standard)
Fig. 2 — System Components
The units listed in Table 3 are addressed in these installation instructions.
NOTE: The installation must be performed in accordance with the
4
Table 3 — Indoor Units
DESCRIPTION
BTUH
6
9
CASSETTE
208/230-1-60
12
18
requirement of local and national standards. The installation
may differ slightly in some areas.
V-PH-HZ
ID MODEL NO.
DLFSOAH09XAK
DLFSOAH18XAK
Advertisement
Table of Contents
