Table of Contents
Advertisement
LISTENING TO THE BROADCAST
e
Check
that all terminals are properly connected
before
switching on the unit.
AUTO TUNING (FM reception)
The electronic tuning circuit inside the unit will search for the
station.
1.
Turn on the POWER switch.
2.
Press the TUNER
switch
of the INPUT
SELECTOR
switches.
3.
Set the BAND selector switches for FM reception.
4.
Press the TUNING MODE AUTO/ MANUAL switch to
establish the AUTO tuning mode (the AUTO indicator
lights).
5.
Press the TUNING switches "UP" or "DOWN "
for a higher or lower frequency as desired.
The frequency will change rapidly during scanning. The
AUTO TUNING will stop automatically when a station is
located and the TUNED indicator also lights up.
NOTE:
When the AUTO TUNING is in use, reception may not be possi-
ble over long distances or when signals are weak. At these times
manual tuning is recommended.
6.
Adjust the VOLUME control and the tone controls.
MANUAL TUNING (FM/AM reception)
6D POORER erncse seveves SX-337
1.
Turn on the POWER switch.
2.
Press the TUNER
switch of the INPUT SELECTOR
switches.
3.
Select your desired broadcasting band using the
BAND selector switches.
4.
Press the TUNING
MODE
AUTO/MANUAL
switch
to
establish the MANUAL tuning mode (the AUTO indicator
goes off).
5.
Use the TUNING switches to locate the frequency of
the desired station.
For step-by-step searching, press the TUNING switch once
and release it immediately. For continuous rapid scanning
keep the TUNING switch pressed. The TUNED indicator
will light up when the desired station is tuned in best.
NOTE:
The TUNED indicator will not function for broadcasts received
over long distances or when signals are weak.
6.
Adjust the VOLUME control and the tone controls.
9
<ARB1233>
Advertisement
Table of Contents
