Pro-Form PFTL15820-INT.0 User Manual page 30

SYMPTOM: The displays of the console do not
function properly
a. If the console does not record speed or distance
correctly, first remove the key from the console and
UNPLUG THE POWER CORD. Next, remove the
five #8 x 3/4" Pan Head Screw (18), and carefully
pivot off the Motor Hood (68).
a
68
18
Next, locate the Reed Switch (124) and the Magnet
(126) on the left side of the Pulley (54). Turn the
Pulley until the Magnet is aligned with the Reed
Switch. Make sure that the gap between the
Magnet and the Reed Switch is about 3 mm
(1/8 in.). If necessary, loosen the #8 x 3/4" Screw
(5), move the Reed Switch slightly, and then
retighten the Screw. Reattach the Motor Hood, and
walk on the treadmill for a few minutes to check for
a correct speed reading.
Top
View
124
5
3 mm
18
18
18
54
126
30
b. If the console does not boot up properly, or
if the console freezes and does not respond,
reset the console to the factory default settings.
IMPORTANT: Doing this will erase all the
custom settings you have made to the console.
Resetting the console requires two people. First,
press the power switch into the off position. Next,
locate the small reset opening (D) on the right side
of the console. Using a bent paper clip (E), press
and hold the reset button inside the opening, and
have a second person press the power switch into
the on (reset) position. Continue holding the reset
button (D) until the console turns on. When the
reset operation is complete, the console will turn off
and then turn back on. If it does not, use the power
switch to turn the treadmill off and then on again.
Once the console turns on, check for firmware
updates (see step 5 on page 24). Note: It may take
a few minutes for the console to be ready for use.
b
E
D