Cambridge SoundWorks Newton II Series User Manual page 8

CONNECTIONS
About your audio components:
You can connect the
P205 to a
receiver,
an
integrated amplifier,
a
preampli-
fier/power amplifier combination
or other audio compo¬
nent with line level or speaker level outputs. For brevity,
this guide will usually refer only to a "receiver.* but the
instructions will also apply to any audio component.
You can connect the P205 to a receiver's line level out¬
put (one or two RCA jacks) or its speaker level outputs,
but not both. Always disconnect the AC power from the
subwoofer enclosure before making or changing any
connections.
Line Level Connections
For most line level connections, you need a signal
cable with an RCA plug at both ends. Connect the
P205 in the following ways:
Dolby Digital* or Dolby Surround" receiver:
Connect
a mono signal cable from the RCA jack output labeled
SUB OUT
(or possibly labeled LFE or just SUB) on the
receiver to either LINE INPUT on the subwoofer.
Preampllfler/power amplifier:
Connect a stereo signal
cable with RCA plugs at each end from the
LEFT
and
RIGHT
preamp outputs to tho
L
and
R
LINE INPUTS
on the subwoofer.
RECEIVER
Dolby Digital and Dolby Surround receiver
Line level connector
Preamplifier/Power amplifier level connectors
8