Cambridge SoundWorks Newton II Series User Manual page 10

To insure you conneci Ihe wires properly (positive to
positive, negative to negative), note which of each
speaker wire's two conductors is 'marked'. This mark¬
ing may be a ridge in the insulation, different colored
conductors or printing on only one side. Use the
marked side of the speaker wire to connect the posi¬
tive speaker terminals. Use the other wire for the nega¬
tive terminals.
Using a small flat bladed screwdriver, loosen the four
set screws inside the Speaker Wire Connector plug.
Following the markings on the subwoofer's connection
panel (for Right positive. Right negative and so on),
insert the correct wires into the plug's openings.
Tighten each set screw to hold the wires in place.
Finally, insert the Speaker Wire Connector plug into the
SPEAKER LEVEL INPUT jack on the input panel.
10