Table of Contents
Advertisement
If you have a large room, or desire very high sound
pressure levels, setting the
-3dB switch
to 35 Hz
will still provide good deep bass, but will allow
greater overall output.
Normal Use:
Afterwards, if you find you want more or less bass out¬
put from your system, either adjust any available tone
controls on your receiver or adjust the volume control
on the subwoofer.
We hope you enjoy the new sonic dimensions your
Newton Series powered subwoofer reveals to you!
Fuse Replacement
The fuse holder is located on the base of the subwoofer.
The P205 uses a metric 5X20mm size fuse, 3.5A.
To replace the fuse:
1) Unplug the AC cord from the AC power source, then
remove the AC power cord from the speaker.
2) Remove the fuse cap with a small, flat blade screw¬
driver (see first and second diagram).
3)
Replaco the fuse inside the fuse cap with another
metric 5X20mm size fuse, 3.5A (see third diagram).
4)
Replace the fuse and cap in the subwoofer.
5)
Restore the sub to an upright position.
6) Connect the AC power cord first to the subwoofer
and then to the power source.
® DODy Digital and Dofcy Surround a
<e
rogsiwed trademarks o» Dcx&y laboratories Licensing Corporate^
14
Advertisement
Table of Contents
