Towing The Machine - Toro 31900A Operator's Manual

Figure 41
2. Slowly rotate the cutting unit down until the pin
contacts the lift-arm plate (A in
g298277
Figure 42).
1. Lift-arm plate
3.
4.

Towing the Machine

If you must tow or push the machine, set the traction
pump to bypass the hydraulic fluid. Move the
machine at a speed below 4.8 kph (3 mph) for a
very short distance.
Important:
damage to the hydraulic pump may result.
If you must move the machine more than a short
distance, transport it on a trailer.
1.
45
Figure 42
Use your foot to press down on the cutting unit,
then pull out on the pin (B in
cutting unit settle into the T
Insert the height-of-cut pins through the
height-of-cut plates and chains.
If you exceed towing limits, severe
Access the bypass valve from under the
machine.
g298288
2. Pin
Figure 42) to let the
position.
RANSPORT