Table of Contents
Advertisement
This VCR
(Recording VCR)
Other VCR
(Playback VCR)
During synchronized editing
*
The EDIT function is activated
automatically.
*
If the linear counter becomes zero,
syncronized editing stop.
*
The COUNTER RESET button
cannot function.
32
| Editing
'Synchronized Assemble Editing
Before You Begin
* Check the LANC mode setting (see page 31).
=o]
Operation
1 Insert a recorded cassette into the other (playback) VCR and a cassette for
recording into this (recording) VCR.
2 Locate the recording start point on this VCR and put this VCR in recording pause
mode.
3 Locate the beginning of the scene to be edited out on the other VCR and put the
other VCR in playback pause mode.
4 Press SYNCHRO EDIT on this VCR. The SYNCHRO EDIT indicator lights up.
Pause mode of both the recording VCR and the playback VCR is released
"
to start editing.
5 Press SYNCHRO EDIT on this VCR at the point where you want to stop
recording.
This VCR enters recording pause mode, and the other VCR enters playback
pause mode.
6 If you have another scene you want to edit, repeat steps 3 to 5.
7 After editing has been completed, press ill STOP on both VCRs.
To make use of the linear counter "OHOOM00S"(zero) for synchronized editing
You can perform synchronized insert editing only when this VCR is used as the
recording VCR and the LANC mode is set to "M."
When the linear counter on this (recording) VCR becomes zero during synchronized
editing, the other (playback) VCR enters playback pause mode and this VCR enters
recording pause mode.
See the instructions on page 29 for operation.
Follow the operation procedures 1, 2 and 3 on page 29.
To start editing, press SYNCHRO EDIT on this VCR.
When the linear counter becomes zero, the other VCR enters playback pause mode
and this VCR enters recording pause mode.
Notes
* When connecting two VCRs, do
not connect them so that both
VCRs are used as a recording
VCR and a playback VCR
simultaneously. Doing so may
cause a humming noise.
* If your recording
VCR is a
monaural unit, make connections
using the VMC-910HG/920HG
cable (not supplied).
*
If your recording VCR is equipped
with the S VIDEO input connector,
you can use the S VIDEO
connecting cabie (supplied) to
Connecting Video Equipment with the
CONTROL S Connector
When using the CONTROL S cable
The synchronized editing using the CONTROL S connector is the same as the
synchronized editing using the LANC connector. This enables you to pause both
VCRs and release pause mode of both VCRs.
You can only perform synchronized editing using the CONTROL S IN connector when
the other VCR has the CONTROL S OUT connector.
Set the Command Mode of the other VCR to VTR2.
Press SYNCHRO EDIT on the other VCR having the CONTROL S OUT connector.
connect to the LINE OUT S VIDEO
connector on the VCR.
Editing | 33
Advertisement
Table of Contents
