Table of Contents
Advertisement
ae
Taking Care of Your EV-C100
Video Head Cleaning
When playback pictures are noisy and hardly visible, or no picture or a black and white picture appears, the video heads
may be contaminated. Clean the video heads using video head cleaning tape V8-25CLH (not supplied) or ask Sony service
personnel to clean the video heads.
Symptoms caused by contaminated video heads
Normal picture
* Rough picture
* Unclear picture
* No picture
Initial
lS
Terminal
Worn Video Heads
if the VCR displays a poor picture after you clean the video heads, you may need to replace them. Consult your dealer or
the Sony Service Center nearest you.
Check
the Video Heads after 1,000 Hours
of Use
This VCR is a high-precision machine, It must record on or play back from magnetic tapes on which the image signals from
the color TV or the video camcorder are recorded.
The video heads or mechanical parts for transporting the tape become contaminated or worn atter extended use. You
should have the VCR checked (cleaning, oiling and replacing of worn parts) after each 1,000 hours of use.
Moisture Condensation
« Main Unit
Do not operate the unit right after having transported it from a cold location to a warm location or in a room where the
temperature rises suddenly, because moisture may condense in the operating section of the unit. Wait for about one
hour before operating the unit on in the new location or keep the rise in room temperature gradual. If the unit is operated
with moisture condensation, the unit and the tape may be damaged
Therefore remove the tape immediately when there is a possibility of moisture condensation or when no picture (ora
monochrome picture) is obtained. To evaporate the moisture rapidly, leave the player turned on without a tape loaded.
+ Cassette
When a cassette tape is carried from a cold place to a warm place, the cassette tape may become wet. When there is
any possibility of moisture condensation, eject the casselte tape and leave it outside of the compartment for about one
hour.
42
Additionat Information
Specifications
System
Video recording system
Rotary two-head helical scanning FM system
Audio recording
Rotary head, FM system (2 channels)
Video signal
NTSC color, ElA standards
Usable cassette
8 mm video format cassettes
Tape speed
SP: approx. 1.43 cm/sec.
LP: approx. 0.72 cm/sec.
Maximum recording time
SP: 2 hours 30 minutes
(with Sony P6-150)
Fast-forward and rewind time
Approx. 4.5 minutes.
(with Sony P6-120 cassette)
VHF/UHF output
Channel 3 or 4 (selectable)
75 ohms, unbalanced
VHF/UHF input
75 ohms, F-type connector
for VHF/UHF IN
Inputs and outputs
Video input
LINE IN VIDEO (phono jack) (1}
Input signal:
1 Vp-p, 75 ohms, unbalanced,
sync negative
Video output
LINE OUT VIDEO (phono jack)}(1}
Output signal.
1 Vp-p, 75 ohms, unbalanced,
sync negative
$ VIDEO inpput
LINE IN S VIDEO
(4-pin, mini-DIN)
Luminace signal:
1Vp-p, 75 ohms, unbalanced,
sync negative
Chrominance signal: 0.286 Vp-p, 75 ohms, unbalanced
S$ VIDEO output
LINE OUT S VIDEO
(4-pin, mini-DIN)
Luminance singal:
1 Vp-p, 75 ohms, unbalanced,
sync negative
Chrominance signal: 0.286Vp-p, 75 ohms, unbalanced
Audio input
LINE IN AUDIO (phono jack)(2)
Input tevel:
-7.5 08s
Input impedance:
more than 47 kilohms
Audio output
LINE OUT AUDIO (phono jack)}(2)
Standard impedance:-7.5 dBs at load impedance
47 kilohms
Output impedance:
tess than 10 kilohms
CONTROL S IN minijack
CONTROL L € Stereo mini-mini jack
General
Power requirements
120 V AC, 60 Hz
Power consumption
12 W (max.}
Operating temperature
5°C to 40°C (41°F to 104°F)
Storage temperature
-20°C to 60°C (-4°F to +140°F)
Dimensions
Approx. 225 x 75 x 252 mm (w/h/d)
(Approx. 8 7/a x 3 x 10 inch)
Weight
Approx. 2.1 kg (4 Ib 10 oz}
Remote Commander RMT-V124B
Remote control system
Infrared control
Command mode
VTR2
Power requirements
3V DC
2 size AA batteries
(IEC designation R6)
Supplied accessories
See page 5.
Additional Information
43
Advertisement
Table of Contents
