Table of Contents
Advertisement
COUNTER RESET
@ STOP
DUAL MODE
SHUTTLE ring
IEE CON >
mil
he
Note
The picture may be distoried a
moment at the cut-out point (recording
'end point),
22 | Advanced Operations
During Playback
You can re-record onto an unwanted portion of a pre-recorded cassette using the
DUAL MODE SHUTTLE ring on the VCR.
1 Press W PAUSE at the end of the unwanted scene during playback.
The VCR enters playback pause mode.
2 Press COUNTER RESET on the VCR to set the linear counter to
"OHOOMO0S"
3 Turn the DUAL MODE SHUTTLE ring counterclockwise until the beginning of the
unwanted scene appears on the screen.
When you release the ring, the VCR enters playback pause mode
Use < DIRECTION > on the Remote Commander to rewind or advance the picture
frame by frame when searching for more specific points.
4 Press @ REC.
The VCR enters recording pause mode.
5 Select a new program for re-recording.
6 Press th PAUSE again to release the pause when the scene to be recorded begins
to appear on the screen.
Recording begins.
7 Press @ STOP when the linear counter shows "OHOOMOOS".
Chapter 5 Editing
Overview of the Editing Functions
Using a second VCR, you can record programs from one VCR to the other.
The following are the tape editing functions available on the VCR.
* To make a copy of a tape
See "Tape Dubbing" on pages 24-26.
Original tape
Copy of tape
—Ss
* To edit out unwanted scenes
See "Assemble Editing" on pages 27 and 28.
Cut out
Cutout
!
Original tape}
4
:
~
\
Edited tape
* To insert another scene into a tape
See "Insert Editing" on pages 27 and 29.
Start point
.
wy
End point
Original tape
J
Start point
y _EAd point
Edited tape
* To edit tapes using the synchronized editing function
if
See "Synchronized Editing" on pages 30-33.
You can also use the synchronized editing function to perform assemble editing and
insert editing if your other VCR has a control L ( @ LANC) connector. Using this
function controls both the playback VCR and the recording VCR simultaneously from
the VCR the LANC mode of which has been set to "M" (see page 31).
Editing
23
Advertisement
Table of Contents
