Table of Contents
Advertisement
Front Panel Controls and Functions
| Tuner section
0
Power
"
6
STANDBY/ON" switch
(POWER, 6 STANDBY/ON)
Press to switch the unit from on to standby mode or vice ver¬
sa. In standby mode, the unit Is still consuming a small
amount of power.
(2) Remote control signal receptor
(REMOTE SENSOR)
Receives the signals from the remote control.
© "STANDBY" Indicator (STANDBY)
When the unit is connected to the AC mains supply, this in¬
dicator lights up in standby mode and goes out when the unit
is turned on.
0 Channel display
This display shows the channel number selected by one of
the preset-tuning buttons.
Also this display shows the channel number for about 3
seconds during memory scan operation.
© Quartz-lock Indicator (QUARTZ LOCK)
This indicator illuminates when the unit is tuned precisely to
a broadcast station.
© Memory indicator (MEMORY)
This indicator illuminates when the memory button is press¬
ed.
0 FM stereo indicator (FM ST)
This indicator automatically illuminates when an FM stereo
broadcast is being received.
Note:
It will not illuminate if the FM mode selector is set to the
monaural mode.
® Memory scan Indicator (M. SCAN)
This indicator illuminates when the memory scan button is
pressed.
© Band Indicators (FM, LW, MW)
Indicates the selected band.
# Input selector/frequency display
(INPUT SELECTOR/FREQUENCY)
Displays the selected source or broadcast frequency.
(
0
)
Memory scan button (MEMORY SCAN)
This button is used to locate a desired broadcast station;
each broadcast station is selected for about 3 seconds.
0 Tuning buttons (TUNING)
These buttons are used for tuning to the desired broadcast
station.
@ Memory button (MEMORY)
This button is used when presetting broadcast station fre¬
quencies into memory. (Refer to pages 15-16.)
0 Preset-tuning buttons (1 -0)
(30 CHANNEL RANDOM PRESET TUNING)
These buttons are used to preset broadcast frequencies into
the memory of this unit and to recall the desired preset sta¬
tions. (Refer to pages 16-17.)
0 Band selectors (FM, LW, MW)
FM: Press this button to listen to an FM broadcast.
LW: Press this button to listen to an LW broadcast.
MW: Press this button to listen to an MW broadcast.
ALLOCATION: When the MW button is pressed for about 3
seconds, the MW frequency step will change to 10 kHz per
step. (This step is set to 9 kHz before shipment.) In order to
return to the original frequency indication, press this button
for about 3 seconds again.
0 FM mode selector (FM MODE)
This unit automatically switches to the stereo mode when an
FM stereo broadcast is received. This selector is used to
select the mode (stereo or monaural) of FM broadcast
signals.
Advertisement
Table of Contents
