Table of Contents
Advertisement
Have you completed the "Memory presettings"
on page 15-16 and steps 1 - 3 of "Mutual Opera¬
tions" on page 12 ?
^ Press the "TUNER" button.
2
Select the desired "CHANNEL".
{Refer to "How to designate preset tuning" on page 16.)
Channel selection using the memory scan
button
This feature is convenient for use when trying to locate a certain
broadcast, or to listen to each station briefly to hear what is being
broadcast.
1 MEMORY SCAN]
Press the memory scan button.
(The memory scan indicator will illuminate.)
Each frequency will then be heard (in sequence) for about 3
seconds.
The preset channel number will be displayed in the channel
display.
When the desired broadcast Is found:
MEMORY SCAN]
Press the memory scan button
(The memory scan indicator will switch OFF.)
The broadcast will continue, even after 3 seconds have passed.
If noise is excessive in the FM mode
Press the FM mode selector.
The sound will then be heard in monaural and the FM stereo in¬
dicator will not illuminate. If the broadcast signal is weak, or if
there is a large amount of interference, sounds can be heard
more clearly.
The back-up function maintains the preset memory and the most-
recent memory (see below) when the power is switched OFF, in
the event of a power failure, or if the power cord is disconnected.
The memory will be maintained for as long as approximately one
month.
Most-recent memory
The most-recent memory system "remembers" the broadcast
station last tuned to when the unit was switched OFF. That sta¬
tion will be automatically tuned to when the power is switched
ON.
Preset channel number
If frequency presettings are accidentally erased
from the back-up memory
Make the frequency presettings (on page 15 or 16) once again.
The power cord should remain connected for one hour or more
for the memory back-up to be effective.
Station Memory File (Use this file to record your memory selections.)
17
Advertisement
Table of Contents
