Drink Holder - Suzuki Jimny 2022 Manual

The accessory socket will work when the
ignition switch is in "ACC" or "ON" position
or the engine switch is in ACC or ON
mode.
This socket can be used to provide 12 volt/
120 watt/10 ampere power for electrical
accessories. Check that the rubber cap
remains on the socket when the socket is
not in use.
When using the accessory socket, open
the rubber cap (1).
WARNING
When the accessory socket is not in
use, closed the rubber cap. If any for-
eign material enters the accessory
socket, it may cause a malfunction or
short circuit.
NOTICE
• To prevent the fuse from being
blown, when using sockets at the
same time, do not exceed the total
combined power capacity of 12
volt/120 watt/10 ampere.
• Use of inappropriate electrical
accessories can cause damage to
your vehicle's electrical system.
Check that any electrical accesso-
ries you use are designed to plug
into this type of socket.
• Check that the cap remains on the
socket when the socket is not in
use.
• When the ignition switch is in
"LOCK" position or the ignition
mode to LOCK (OFF) during using
the accessory socket, the following
accidents may occur;
– the audio or navigation system
does not turn off.
– the keyless entry system does
not work, etc.
• If they occur, disconnect the item
from the accessory socket and
check whether the electrical equip-
ments work properly.
If the problem persists, ask an
authorized SUZUKI dealer or a
qualified workshop to have the sys-
tem inspected.
OTHER CONTROLS AND EQUIPMENT

Drink Holder

Use the drink holder to put a cup with a lid
or a bottle with a cap. Also, you can put
small articles in the drink holder.
80T070260
7-10
80TS - 01E