Suzuki Jimny 2022 Manual page 246

OPERATING YOUR VEHICLE
Changing Cruising Speed
Using the accelerator pedal
To reset at a faster cruising speed, acceler-
ate to the desired speed using the accelera-
tor pedal and push down the "RES +/SET –"
switch (3). The new speed will be main-
tained.
Using the brake pedal
To reset at a slower cruising speed, decel-
erate to the desired speed using the brake
pedal and push down the "RES +/SET –"
switch (3). The new speed will be main-
tained.
NOTE:
When the brake pedal is depressed, "SET"
indicator (5) will go off until you reset the
cruising speed.
Using "RES +/SET –" switch
To reset at a faster cruising speed, press
repeatedly or hold push up the "RES +/
SET –" switch (3). Vehicle speed will
steadily increase. When you release the
switch, the new speed will be maintained.
To reset at a slower cruising speed, press
repeatedly or hold push down the "RES +/
SET –" switch (3) until the vehicle has
slowed to the desired speed, and then
release the switch. The new speed will be
maintained.
5-45
NOTE:
• You can adjust the set speed by approx-
imately 1 km/h (1 mph) by pushing
"RES +/SET –" switch quickly.
• When the current vehicle speed is about
10 km/h (6 mph) or more faster than the
previously set speed, the cruising speed
cannot be decreased even if the "RES +/
SET –" switch (3) is pushed down.
• When the current vehicle speed is about
10 km/h (6 mph) or more slower than the
previously set speed, the cruising speed
cannot be increased even if the "RES +/
SET –" switch (3) is pushed up.
Canceling Cruise Control
"SET" indicator (5) will go off and the
cruise control will be canceled temporarily
with the following conditions:
• Push "CANCEL" switch (2)
• Depress the brake pedal
• For manual transmission, depress the
clutch pedal
• For automatic transmission vehicle, the
gear position is changed to "L"
• The vehicle speed falls more than about
20 percent from the set speed
• Any time the vehicle speed falls below
40 km/h (25 mph)
• When the vehicle skids and ESP
activated
• If the automatic brake system is working
• When the transfer lever is operated
To resume the previously set speed, push
up the "RES +/SET –" switch (3) and turn
on "SET" indicator (5). The vehicle speed
must be above 40 km/h (25 mph) when the
vehicle is not under the above conditions.
To turn off the cruise control system, push
cruise switch (1) and check that the cruise
indicator (4) is off.
Also, if the malfunction indicator light in the
instrument cluster comes on or blinks, the
cruise control system will be turned off.
NOTE:
If you turn off the cruise control system, the
previously set speed in the memory is
cleared. Reset your cruising speed again.
®
is
80TS - 01E