Suzuki Jimny 2022 Manual page 310

OPERATING YOUR VEHICLE
61MM0A199
NOTE:
For a certain type of instrument cluster
only, the information display shows the
above warning and indicator message
when this light comes on.
5-109
TPMS Limitations
The tyre pressure monitoring system may
not function properly under certain circum-
stances. In the following situations, the low
tyre pressure warning light may come on
and remain on or may blink.
• When you replace a flat tyre with the
spare tyre.
• When you include a spare tyre during a
tyre rotation.
• When the TPMS sensor is damaged
during a tyre replacement or liquid seal-
ants are used to repair a flat tyre.
• When the electronic signal of TPMS sen-
sor is disturbed in one of the following
ways:
– Electric devices or facilities using simi-
lar radio wave frequencies are nearby.
– A metallic film that may cause radio
wave interference is attached on the
window.
– A lot of snow or ice covers the vehicle,
in particular, around the wheels or
wheel housings.
– Snow tyres that are not installed with
genuine TPMS sensors or snow
chains are used.
• When you use non-genuine SUZUKI
wheels or tyres.
• When the pressure of any tyre is too
high.
• When there is a problem with the
receiver of the TPMS controller.
TPMS Setting
• You can check the current tyre pressure
on the information display.
• You can set one of the initial value of tyre
pressure below that is indicated on the
tyre information label.
– Comfort Mode
– Load Mode
WARNING
If the loading weight has changed,
adjust the tyre pressure according to
the tyre information label and set the
initial value via the information dis-
play. If the loading weight, tyre pres-
sure and initial value do not match,
the tyre pressure monitoring system
will not function properly.
80TS - 01E