Table of Contents
Advertisement
1.
Fill an approved clean one-gallon container with one quart
fresh unleaded gasoline. See figure 2.
2.
Pour recommended amount of 2.5 oz. high quality two cycle oil
into the gasoline container.
Note: Do not use multiviscosity oils such as 10W-30 or 10W-40.
3.
Put the cap back on the gasoline container, tighten it, and shake the
container vigorously so that the oil and gasoline mix.
4.
Unscrew the cap and fill the container with three quarts of gas¬
oline. Shake the container again. See figure 2.
5.
Remove the fuel tank cap and carefully pour mixed gasoline
into the fuel tank, filling to 1/2 inch below the filler neck to allow
room for expansion. Shake the gasoline container each time
before filling the fuel tank.
Caution:
Never put plain, unmixed gasoline into the fuel tank.
Note: You can use gasoline containing up to 10% ethanol or grain
alcohol (gasohol), but make sure that you follow the engine manu¬
facturer's special instructions for engine care when the engine is not
used for an extended period. See Storage Instructions in the engine
manual for that information.
WARNING
• Always fill up :
the fuel tank Z.
outdoors or
; in a well-ventM
latedarea.
j
• Use a funheT?|
or spout to 'lj
prevent spill- 3
• If there
,J^ttemptingyto|
;startther%V |
• Never f Ilf up
•2 the gas tank :
while the
§§l|f '
^engine is run
fining or is hot.1
• s Do not smoke,
ir; while mixing ™
-. the gasoline |f
•and oiforJIF.
M ing up the fuel ]
:*
,-3
&SK8e35H5!
5
Advertisement
Table of Contents
